Overview - Charge Air System
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Seal
- Replace after removing
- Alignment Pin
- Bolt
- 8 Nm
- Seal
- Replace after removing
- Bolt
- Tightening specification List Item: Bolt .
- Bracket
- For intake manifold
- Bolt
- Tightening specification List Item: Bolt .
- Bolt
- Replace
- Tightening specification and sequence. Refer to Fig 3.
- Alignment Pin
- Bolt
- 8 Nm
- Intake Manifold with Charge Air Cooler
- The intake manifold with charge air cooler are one unit.
- Checking for leaks. Refer to CHARGE AIR SYSTEM, CHECKING FOR LEAKS .
- Removing and Installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
- Bolt
- Replace
- Tightening specification and sequence. Refer to Fig 3.
- Charge Air Temperature Sensor after Charge Air Cooler -G811-
- Removing and Installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
- 22 Nm
- Seal
- Replace after removing
- Connection
- For the Throttle Valve Control Module -J338-
- Charge Air Temperature Sensor In Front of Charge Air Cooler -G810-
- Removing and Installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
- 22 Nm
- Bolt
- not individually available
- 10 Nm
- Coolant Pipe
- not individually available
- Bolt
- not individually available
- 10 Nm
- Coolant Pipe
- not individually available
- O-Rings
- not individually available
- Coat with coolant
- Throttle Valve Control Module -J338-
- With Throttle Position Sensor -G69-
- Removing and Installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing
- Air Duct Pipe
- Bolt
- 8 Nm
- Bracket
- For the Throttle Valve Control Module -J338-
- Bolt
- Tightening specification and sequence. Refer to Fig 4.
- Bolt
- Tightening specification and sequence. Refer to Fig 4.
Charge Air Pressure Sensor G31 - Tightening Specification
-- Tighten the bolt -2- to 9 Nm.