LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2018 >> A6 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Lighting System (Exterior) (Service Information)) >> Hazard Warning Switch >> Removal [08/2013 - ] >> Removal [08/2013 - ]

Removal [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION (for Multi-Media Module Receiver Type) 
    NOTE:
    • After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work. Refer to PRECAUTION [08/2013 - ] .
    • A Hard Disk Drive (HDD) is built into the multimedia module receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the multi-media module receiver assembly.
    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.
  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)  . Refer to CUSTOMIZE PARAMETERS [08/2013 - ] - Step 1
  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for Multi-Media Module Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 2
  4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL (for Multi-Media Module Receiver Type) 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION [08/2013 - ] .

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  . Refer to REMOVAL [08/2013 - ] - Step 11
  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH  . Refer to REMOVAL [08/2013 - ] - Step 12
  7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY  . Refer to REMOVAL [08/2013 - ] - Step 13
  8. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL  . Refer to REMOVAL [08/2013 - ] - Step 14
  9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 9
  10. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET (for Multi-Media Module Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 9
  11. REMOVE NO. 1 RADIO BRACKET (for Radio Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 11
  12. REMOVE NO. 2 RADIO BRACKET (for Radio Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 12
  13. REMOVE RADIO RECEIVER ASSEMBLY (HAZARD SWITCH) (for Radio Receiver Type) 
  14. REMOVE NO. 1 RADIO BRACKET (for Multi-Media Module Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 10
  15. REMOVE NO. 2 RADIO BRACKET (for Multi-Media Module Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 11
  16. REMOVE HARD DISK DRIVE (for Multi-Media Module Receiver Type)  . Refer to REMOVAL [08/2013 - ] - Step 11
  17. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (HAZARD SWITCH) (for Multi-Media Module Receiver Type) 
scientia non olet · About LEMON Manuals