Removal [08/2013 - ]

WARNING: This page is about a different car, the 2014 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE LANE DEPARTURE WARNING CAMERA COVER (w/ Lane Departure Alert System) . Refer to REMOVAL [08/2013 - ] - Step 1
REMOVE RAIN SENSOR COVER (w/o Lane Departure Alert System)
1. Disengage the 2 claws and remove the rain sensor cover as shown in the illustration.
  
  Fig 1: Identifying Rain Sensor Cover (W/O Lane Departure Alert System) Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RAIN SENSOR
1. Disconnect the connector.
  
  Fig 2: Identifying Rain Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.
  
  Fig 3: Identifying Rain Sensor Stopper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  TEXT IN ILLUSTRATION
  
  *1 Stopper
CLEAN WINDSHIELD GLASS
HINT:
- The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.
- Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.