Trailing Arm, Servicing

Special tools and workshop equipment required 

• Press Plate: VW402 
• Press Piece - Multiple Use: VW412 
• Bearing Installer - Wheel Bearing: 3345 
• Bearing Installer - Control Arm: 3346 
• Press Piece - Trailing Arm Bushing: T10496 

Procedure 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the trailing arm with the mounting bracket. Refer to TRAILING ARM WITH MOUNTING BRACKET, REMOVING AND INSTALLING .

-- Clamp the trailing arm -1- in the vise with protective covers.

-- Remove the bolt -2- and remove the mounting bracket -3- from the trailing arm.

-- Mark the installation position of the bonded rubber bushing on the trailing arm.

-- To do so, make a mark over and under the bushing on the trailing arm -arrows- between the raised areas -1- as illustrated.

Bonded Rubber Bushing, Pressing Out 

Courtesy of AUDI OF AMERICA, LLC

-- Mount the tools as illustrated.

1. : VW412 
2. : 3346/1  from the : 3346 
3. Trailing arm
4. Bonded rubber bushing
5. : 3345 
6. : VW401 

-- Press out the bonded rubber bushing.

Bonded Rubber Bushing, Pressing On 

• Position the bonded rubber bushing on the trailing arm so that the marked line -arrows- is between the raised areas -1-.

-- Mount the tools as illustrated.

Courtesy of AUDI OF AMERICA, LLC

1. : VW412 
2. : T10496 
3. Bonded rubber bushing
4. Trailing arm
5. : 3345 
6. : VW402 

-- Install the bonded rubber bushing.

-- Attach the trailing arm to the mounting bracket. Refer to REMOVING - Mounting Bracket Installation Position to Trailing Arm, Adjusting .

-- Install trailing arm with mounting bracket. Refer to TRAILING ARM WITH MOUNTING BRACKET, REMOVING AND INSTALLING .