Trailing Arm With Mounting Bracket, Removing And Installing: Removing

-- Remove the wheel. Refer to WHEELS AND TIRES .

-- Remove the coil spring. Refer to SPRING, REMOVING AND INSTALLING .

-- Remove the brackets -arrows- by pressing out the rivet inner pins.

Courtesy of AUDI OF AMERICA, LLC

-- Free up the wiring harness -3-.

-- Remove the bolts -1 and 2- from the trailing arm.

-- Remove the respective underbody trim panel. Refer to UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .

-- Remove the wire -2- from the bracket -1-.

-- Mark the mounting bracket -1- installation position on the body.

-- Remove the bolts -arrows-.

-- Remove the trailing arm with mounting bracket.

• If the mounting bracket is separated from the trailing arm for the following steps, the installation position of the mounting bracket to the trailing arm must then be adjusted.

-- Clamp the trailing arm in the vise with protective covers.

Mounting Bracket Installation Position to Trailing Arm, Adjusting 

Dimension -a- is 37 mm.

1 -  Trailing arm

2 -  Mounting bracket

• Place a steel ruler on the mounting bracket as shown and adjust to the dimension given above. Make sure that the steel ruler is resting completely on the mounting bracket and is positioned at the inner edge of the trailing arm.

-- When dimension -a- has been adjusted, tighten the bolt -3-.