LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 75 (Front Suspension [Coupe]) >> 40 Front Suspension >> SUBFRAME >> SUBFRAME, Lowering >> Installing

SUBFRAME, Lowering: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Coat the seal on the steering gear with lubricant such as soft soap before installing the steering gear.

After placing steering gear onto universal joint, make sure that seal -item 13- Seal on steering gear makes contact on assembly plate without kinks and opening to footwell is correctly sealed. Ingress of water and/or noises may be the result.

Make sure sealing surfaces are clean.

CAUTION:

There is a risk of damaging the threads on the subframe threaded connection to the body.

  • The subframe bolts on the body must not be loosened or tightened with an impact wrench.
  • Always install all bolts by hand for the first few turns.

-- Remove the : T10486/1  . Refer to SUBFRAME, SECURING - T10486/1, Removing .

-- Evaluate if an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .

scientia non olet · About LEMON Manuals