LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 63 (Mechanical Components (Brake System) [Coupe]) >> 46 Mechanical Components >> Front Brakes 1LK/1LH TTS >> Shield, Removing And Installing, 1LK/1LH TTS >> Installing

Shield, Removing And Installing, 1LK/1LH TTS: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Clean bolts before reusing.

Replace damaged bolts.

Always replace self-locking bolts.

-- Clean the brake shield and the wheel hub.

-- Insert the shield and tighten to 12 Nm.

-- Install the corresponding brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING, 1LK/1LH TTS .

WARNING:

After installing the brake caliper check that the spring and brake pads for correct seating. Refer to BRAKE PAD RETAINING PLATE .

WARNING:

Risk of accident!

  • With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly set in their respective position.
  • Make sure the brakes are working correctly before driving the vehicle for the first time.
scientia non olet · About LEMON Manuals