Brake Rotor, Removing And Installing, 1LK/1LH TTS: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Clean bolts before reusing.

Replace damaged bolts.

Always replace self-locking bolts.

-- Before reusing brake rotors check for wear and damage.

WARNING:

If a brake rotor is damaged or worn, check the other brake rotors for damage and wear.

-- Thoroughly clean the brake rotor and hub contact surfaces and free them of corrosion.

-- Place the brake rotor on the wheel hub.

NOTE:

Do not tilt the brake rotor when mounting it on the wheel hub.

-- Tighten the bolt -arrow- to 5 Nm.

Fig 1: Identifying Bolt And Brake Rotor

Courtesy of AUDI OF AMERICA, LLC

-- Install the corresponding brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LK/1LH TTS .

WARNING:

After installing the brake caliper check that the spring and brake pads for correct seating. Refer to BRAKE PAD RETAINING PLATE .

WARNING:

Risk of accident!

With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly set in their respective position.
Make sure the brakes are working correctly before driving the vehicle for the first time.