LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 63 (Mechanical Components (Brake System) [Coupe]) >> 46 Mechanical Components >> Brake Pedal >> Mounting Bracket, Removing And Installing >> Installing

Mounting Bracket, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
NOTE:

Clean bolts before reusing.

Replace damaged bolts.

Always replace self-locking bolts.

Install in reverse order of removal and note the following:

NOTE:

Replace the nuts after removing.

-- Bring the mounting bracket with the installed brake pedal into the installation position.

NOTE:

Make sure that the wire for the accelerator pedal module is free and not pinched when inserting the mounting bracket.

Make sure that the mounting bracket sits in all stud bolts.

-- Attaching to brake booster. Refer to BRAKE PEDAL, ATTACHING TO BRAKE BOOSTER .

-- Install the crash bolster. Refer to OVERVIEW - INSTRUMENT PANEL CROSSMEMBER .

WARNING:

Risk of accident!

  • Make sure the brakes are working correctly before driving the vehicle for the first time.
scientia non olet · About LEMON Manuals