Overview - Fuel Tank, Vehicles With Fwd
WARNING: This page is about a different variant/trim than selected.
- Bolts
- 20 Nm +90°
- Replace after removing
- Fuel Supply Line
- To the engine
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Vent Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bracket
- For Fuel Pump Control Module -J538-
- Fuel Tank
- Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING, FWD VEHICLES .
- Bolt
- 20 Nm +90°
- Replace after removing
- Bolt
- 8 Nm +90°
- Replace after removing
- To attach the fuel filler neck
- For discharging electrostatic charge. Refer to GROUND CONNECTION FOR DISCHARGING ELECTROSTATIC CHARGE, ROUTING AND SECURING
- Ground Connection
- For the fuel filler neck
- For discharging electrostatic charge. Refer to GROUND CONNECTION FOR DISCHARGING ELECTROSTATIC CHARGE, ROUTING AND SECURING
- Bolt
- 8 Nm +90°
- Replace after removing
- Vent Line
- To the EVAP Canister
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bleeder Line
- To the EVAP Canister
- Only through MY 2018
- Clipped to the fuel tank
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Heat Shield
- For the fuel tank
- Bolt
- 20 Nm +90°
- Replace after removing
- Nut
- 2 Nm
- For the heat shield
- Mounting Strap