Overview - Fuel Tank, Vehicles With AWD

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Fuel Tank, Vehicles With AWD

Courtesy of AUDI OF AMERICA, LLC

Heat Shield
- For the fuel tank
Right Mounting Strap
Bolt
- 20 Nm +90°
- Replace after removing
Fuel Line
- To the engine
- Do not kink
- Clipped to the fuel tank
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Vent Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Do not kink
- Clipped to the fuel tank
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Bracket
- For Fuel Pump Control Module -J538-
Fuel Tank
- Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING, ALL WHEEL DRIVE VEHICLES .
Bolt
- 8 Nm +90°
- Replace after removing
- To attach the fuel filler neck
- For discharging electrostatic charge. Refer to GROUND CONNECTION FOR DISCHARGING ELECTROSTATIC CHARGE, ROUTING AND SECURING
Ground Connection
- For the fuel filler neck
- For discharging electrostatic charge. Refer to GROUND CONNECTION FOR DISCHARGING ELECTROSTATIC CHARGE, ROUTING AND SECURING
Bolt
- 8 Nm +90°
- Replace after removing
Vent Line
- To the EVAP Canister
- Do not kink
- Clipped to the fuel tank
- Connector Couplings, Separating and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Bleeder Line
- To the EVAP Canister
- Only through MY 2018
- Do not kink
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
Bolts
- 20 Nm +90°
- Replace after removing
Left Mounting Strap
Bolt
- 20 Nm +90°
- Replace after removing
Bolt
- 20 Nm +90°
- Replace after removing
Nuts
- 2 Nm
- For the heat shield