Overview - Engine Oil Cooler
WARNING: This page is about a different variant/trim than selected.
- Sub-Assembly Bracket
- Removing and installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Seal
- Always replace after removing
- O-Rings
- Always replace after removing
- Coat with engine oil
- Mechanical Switch Valve
- Removing and installing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
- Engine Oil Cooler
- See note. Refer to If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent subsequent damage. Replace the additional oil spray jet, engine oil cooler and oil filter. .
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing.
- Coat with coolant
- Quantity: 2
- Connection
- Bolt
- 8 Nm +45°
- Always replace after removing