Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn after removing them.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging threads in transmission support by inserting bolts at an angle.

The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.
Remove the :10-222A only when the bolts for the subframe mount have been tightened to the tightening specification.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Check the adjustment of the subframe mount. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the :10-222A from the engine.

-- Install the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .