SUBFRAME Mount, Checking Adjustment

WARNING: This page is about a different variant/trim than selected.

Procedure

The following dimensions must be attained:

Fig 1: Identifying Distance And Dimension

Courtesy of AUDI OF AMERICA, LLC

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
The casting edge on the engine support must be parallel to the engine mount support arm.
Dimension -b- = dimension -b-.

NOTE:

Distance -a- = 10 mm can also be checked with corresponding round stock.

-- If the distance measured is too small or too large, adjust the subframe. Refer to SUBFRAME MOUNT, ADJUSTING .