Air Distribution Housing, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

Tightening specification. Refer to HEATER AND A/C UNIT, DISASSEMBLING AND ASSEMBLING .

NOTE:

The smallest leaks at the tongue and groove joint between the air distribution housing and the evaporator housing can lead to whistling noises due to escaping air. Lightly coat the connection points with silicone grease, for example. Silicone grease. Refer to the Parts Information.

-- Install the heater and A/C unit. Refer to HEATER AND A/C UNIT, REMOVING AND INSTALLING .

-- Install the remaining components.

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the"Guided Fault Finding" function.

-- Check the heating and A/C system function.