Right Seal, Replacing, AWD Vehicles

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING .

-- Place the : SMN372500 underneath.

-- Pry out the seal on the transmission using the : T20143/1 or : T20143/2 .

-- Coat the outer edge and sealing lips on the new seal with transmission fluid.

Fig 1: Identifying Oil Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing/dust lip -arrow- halfway with sealing grease. Refer to the Parts Information for the correct Sealing Grease.

-- Drive the new seal all the way in using the : T10243 . Do not tilt the seal while doing so.

Fig 2: Carefully Drive In Sealing Ring As Far As Stop Using Thrust Piece T10243

Courtesy of AUDI OF AMERICA, LLC

-- Install the bevel box. Refer to BEVEL BOX, INSTALLING .

-- Check the transmission fluid level. Refer to TRANSMISSION FLUID LEVEL, CHECKING .