LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> TT Quattro Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Controls, Housing [Coupe]) >> 34 Controls, Housing >> MECHATRONIC >> Transmission Fluid Pan, Removing And Installing >> Removing

Transmission Fluid Pan, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Remove the air filter housing:

-- Drain the transmission fluid. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .

-- Remove the nuts -arrows- and remove the front bracket from the transmission fluid pan.

GWWA34-11073Courtesy of AUDI OF AMERICA, LLC

-- Turn the twist lock counter-clockwise -arrow- to disconnect the connector -1- for the Dual-Clutch Transmission Mechatronic -J743-.

GWWA34-11219Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk of Destroying Due to Electrostatic Charge.

- Do not touch the connector terminals.

- Touch a grounded object (for example the hoist) and discharge any static electricity.

Vehicles with 1.8L/2.0L TFSI Engine: 

GWWA21-10943Courtesy of AUDI OF AMERICA, LLC

-- If installed, loosen the hose clamps -1 and 2- and remove the air duct hose.

All Vehicles: 

Fig 1: Exploded View Of Transmission Oil Pan
GWWA37-0672Courtesy of AUDI OF AMERICA, LLC

-- Place the : SMN372500  underneath.

-- Loosen the bolts -arrows- diagonally.

-- Remove the transmission fluid pan -A- with the transmission fluid pan gasket. While doing so, allow the transmission fluid remaining in the transmission fluid pan to drain into the : SMN372500  .