Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive Belt Routing (Engine Code: CALB)

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Route the ribbed belt over the ribbed belt pulley in the sequence specified.

Generator
Idler Roller
Coolant Pump
Power Steering Pump
A/C Compressor
Ribbed belt tensioner
Vibration Damper with Ribbed Belt Pulley

NOTE:

When installing the ribbed belt, make sure it is seated correctly on the pulleys.

-- Start the engine and check the belt routing.

-- Install the noise insulation, refer to FRONT NOISE INSULATION .