Left Seal, Replacing, 0BE, 0BF: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Install Right Shaft Seal

Fig 1: Identifying Flange Shaft Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

Installing Left Shaft Seal

Fig 2: Identifying T40221

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Install the flange shaft.

NOTE:

If it is not possible to install the flange shaft all the way in by hand, then use a plastic hammer.

-- Tighten the new flange shaft bolt to the tightening specification -item 1- in FINAL DRIVE 0BE, 0BF OVERVIEW .

-- Install the rear final drive. Refer to FINAL DRIVE .

-- Check the ATF level in the rear final drive. Refer to ATF LEVEL, CHECKING, 0BE, 0BF .