ATF Level, Checking, 0BE, 0BF
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Test Requirement
- ATF temperature: 10° C to 60° C (50° F to 140° F)
- The rear final drive must be in the installed position.
- The vehicle must be horizontal.
Special tools and workshop equipment required
- Drip Tray
-- Remove the ATF inspection plug -1- to check the ATF level.
CAUTION:
- The inspection plug for checking the ATF level -1- is located on the left side of the rear final drive. Identification "ATF" on the final drive housing -arrow-
- ATF plug overview, refer to GEAR OIL DRAIN AND INSPECTION PLUGS OVERVIEW .
- The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.
If the ATF is correct:
-- Install the new ATF inspection plug and fasten. Tightening specification -item 12- in FINAL DRIVE 0BE, 0BF OVERVIEW .
If the ATF is not correct:
-- Fill the ATF. Refer to ATF, FILLING, 0BE, 0BF .