Attach the hydraulic control unit -1- to the rear final drive as follows:

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

First install the lines -6 and 7- into the chambers hand-tight -arrows B-.

Then install the bolts -2 through 5- hand-tight. One bolt -2- has a permanent seal on the head. Coat the thread with Sealing Compound D 176 501 A1.

Tighten the M8 x 30 bolts -2 through 5- to the tightening specification in this sequence: -4, 2, 5 and 3-.

Tighten the nuts -arrows A and arrows B- on the left -6- and right -7- lines to the tightening specification.

-- Install the All Wheel Drive Pump -V415-. Refer to All Wheel Drive Pump -V415-, 0BE, 0BF .

-- Install the wiring harness -3- to the final drive and subframe -5 through 7-.

Fig 1: Identifying Rear Final Drive Wiring Harness Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connectors -4 and 2-. Pay attention to the marks made during the removal, that identify which connector goes to the Oil Pressure/Temperature Sensor -- and which connectors go to the Clutch Valves --.

-- If equipped, position the wiring harness bracket -1- on the rear final drive and tighten the bolts -arrows- to the tightening specification. Make sure the wiring harness -3- does not get pinched.

NOTE:

Allocation for the Oil Pressure/Temperature Sensor -- and Clutch Valves -- connectors:

Fig 2: Identifying Oil Pressure/Temperature Sensor Connectors

Courtesy of AUDI OF AMERICA, LLC

-1- = Oil Pressure/Temperature Sensor 2 -G640- connector

-2- = Oil Pressure/Temperature Sensor -G437- connector

-3- = All Wheel Drive Clutch Valve 2 -N446- connector

-4- = All Wheel Drive Clutch Valve -N445- connector

-- Fill the rear final drive with gear oil and then check the level. Refer to GEAR OIL, CHECKING LEVEL, 0BE, 0BF .

-- Fill the ATF in the rear final drive and check the ATF level. Refer to ATF LEVEL, CHECKING, 0BE, 0BF .

-- Install the rear section of the exhaust system and align it so it is free of tension. Refer to [For engine(s) CEUC,CRDB] Exhaust System, Emission Controls [For engine(s) CTUA,CGXB] Exhaust System, Emission Controls [For engine(s) CPNB] Exhaust System, Emission Controls .