Overview - Flywheel And Dual Clutch: Notes
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Flywheel
- Refer to the parts information because there are different versions depending on the date of manufacture.
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Clutch Cover
- There are different versions depending on the date of manufacture, with or without a thrust washer allocation. (Refer to 7 Thrust Washer).
- Removing. Refer to DSG CLUTCH, REMOVING .
- Installing. Refer to DUAL CLUTCH, INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Tightening Specifications
- O-Ring
- Replacing
- Dual Clutch
- Refer to the parts information because there are different versions depending on the date of manufacture.
- Removing. Refer to DSG CLUTCH, REMOVING .
- Installing. Refer to DUAL CLUTCH, INSTALLING .
- Perform the relevant "Guided Function " using the Vehicle Diagnostic Tester after replacing the dual clutch. .
- Transmission Housing
- Thrust Washer
- Depending on the date of manufacture, clutch cover allocation.
- Ball Bearing
- For the dual clutch
- Replacing. Refer to INPUT SHAFT BALL BEARING, REPLACING .
- Locking Ring
- Replacing
- For ball bearing
- Locking Ring
- Replacing
- For the dual clutch
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Bolt
- 60 Nm
- Replacing