LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 7 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Transmission System (Clutch - Service Information - 7-Speed Dual Clutch - 0B5 - 1 Of 2)) >> 30 Clutch >> Clutch >> Overview - Flywheel And Dual Clutch >> Tightening Specifications

Tightening Specifications

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Flywheel And Dual Clutch Tightening Sequence
GWWA30-10130Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts in three steps in the sequence shown:

Step Bolts Tightening Specification
1. -1 to 5- Install by hand evenly until the bolt head contact the clutch cover.
2. -1 to 5- Tighten one after the other in 90° steps until the clutch cover contact the transmission housing.
3. -1 to 5- 10 Nm
scientia non olet · About LEMON Manuals