LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (GENERIC SCAN TOOL [CNTA, CNTC, CNSB] (4 Of 5) -- (A3 SEDAN)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 06 - Read Test Results For Specific Diagnostic Functions, 2014 - 2015 My, A3 CNTA, CNTC Engine >> Monitor - Id $71: Secondary Air Injection System Bank 1

Monitor - Id $71: Secondary Air Injection System Bank 1

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- CONNECT: Scan Tool

-- START ENGINE: Idle

-- SELECT: Mode 06

-- SELECT: "Monitor - ID $71"

-- SELECT: "Test - ID".

-- CHECK: values listed below at idle.

Test - ID DTC Component or System Min. Max. Additional Information
$82 P0491 System Test, Reduced Secondary Air Mass. 0.0 1.999 Refer to DTC P0491 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P0491
$85 P0410 Pressure Sensor Fault. 0.0 kPa 5.0 kPa Refer to DTC P0410 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P0410
$8C P2440 Secondary Air Injection Valve Functional Test, Valve Leak Check. 0.0 1.34 Refer to DTC P2440 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P2440

-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .

-- Switch the ignition off.

scientia non olet · About LEMON Manuals