Monitor - Id $35: Camshaft Adjustment / IVVT Diagnosis Bank 1
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- CONNECT: Scan Tool
-- START ENGINE: Idle
-- SELECT: Mode 06
-- SELECT: "Monitor - ID $35"
-- SELECT: "Test - ID".
-- CHECK: values listed below at idle.
| Test - ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $80 | P0011 | VVT Intake Camshaft Diagnosis, Specified Position Is Not Reached, Target Error. | 0.0° CRK | 10.0° CRK | Refer to DTC P0011 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P0011 |
| $81 | P000A | VVT Intake Camshaft Diagnosis, Specified Position Is Reached Too Slowly, Slow Response. | 10.0° CRK | 655.35° CRK | Refer to DTC P000A in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P000A |
| $82 | P0014 | VVT Exhaust Camshaft Diagnosis Target Position Is Not Reached The Target Error. | 0.0° CRK | 10.0° CRK | Refer to DTC P0014 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P0014 |
| $83 | P000B | VVT Exhaust Camshaft Diagnosis, Target Position Is Reached Too Slow, Slow Response. | 3.5° CRK | 655.35° CRK | Refer to DTC P000B in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P000B |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.