Monitor - Id $3D: EVAP Valve Function Check
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- CONNECT: Scan Tool
-- START ENGINE: Idle
-- SELECT: Mode 06
-- SELECT: "Monitor - ID $3D"
-- SELECT: "Test - ID".
-- CHECK: values listed below at idle.
| Test - ID | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| $8B | P0441 | Tank Vent Valve - Function Check, Test Using Cross - Correlation. | 0.1 | 65, 535.0 | Refer to DTC P0441 in the DTC summary table. Engine Control Module, 2014 - 2015 MY -- => P0441 |
-- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTC's or the corresponding diagnostic repair procedure DIAGNOSTIC MODE 03 - READ DTC MEMORY .
-- Switch the ignition off.