Rear Axle Camber, Adjusting: Procedure
NOTE:
In the following procedure, a vehicle with Front Wheel Drive (FWD) is shown.
-- Remove the nut -A- on the upper control arm threaded connection from the subframe and loosely install a new nut.
- The eccentric bolt -B- can also be turned by turning the hex head at the "top of the bolt".
-- Set the camber by turning the eccentric screw -B- using the 18 mm socket -1-.
NOTE:
The maximum adjustment range is 90° to left or right of center position.
-- Tighten the nut -A- using the :T10179 .
-- Use the :T10179 -1- as shown.
-- After the nut -A- is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .