Bearing Bracket, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi Q3 Quattro, 2016 Audi Q3, 2015 Audi Q3 Quattro, and 2015 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the bolts -arrows- and tighten them.

-- Lubricate the hole -arrow- with engine oil.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk of damaging the bearing bracket.

Carefully attach the bearing mount, without tilting.

-- Mount the bearing bracket and the bolts -arrows- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

-- Depending on the version, remove either the :T40011 or the :T40267 .

-- Tighten the bolts -arrows-. Refer to OVERVIEW - CAMSHAFT TIMING CHAIN .

-- Install the bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the control valve -Item 6- OVERVIEW - CAMSHAFT TIMING CHAIN.

Installation is performed in reverse order of removal, noting the following:

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .