Overview - Camshaft Timing Chain
WARNING: This page is about a different car, the 2016 Audi Q3 Quattro, 2016 Audi Q3, 2015 Audi Q3 Quattro, and 2015 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension
- Remove the Locking Pin :T40011 before removing
- Timing Chain Tensioning Rail
- Guide Pins
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Left thread
- Depending on the version, remove with either the Central Valve Assembly Tool :T10352 or Central Valve Assembly Tool :T10352/1A
- Bolt
- M6: 8 Nm + 90°
- M8: 20 Nm +90°
- Always replace
- Washer
- Bearing Bracket
- Removing and Installing. Refer to BEARING BRACKET, REMOVING AND INSTALLING .
- Camshaft Timing Chain Glide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Camshaft Timing Chain Glide Rail
- Guide Pins
- 20 Nm
- Three Stage Chain Sprocket
- Crankshaft
- Installed position. Refer to the illustration below
- Both surfaces must -arrows- must line up across from each other.