Component Locations Overview - Electrical Components, Generation V

Refer to ALL WHEEL DRIVE CLUTCH IDENTIFICATION 

Fig 1: Electrical Components, Generation V Component Locations

Courtesy of AUDI OF AMERICA, LLC

1. All Wheel Drive Control Module -J492-
   • Important signals are transmitted from the engine control module and ABS Control Module -J104- via the Data bus to the All Wheel Drive Control Module -J492-.
   • Removing and installing. Refer to All Wheel Drive Control Module -J492-, REMOVING AND INSTALLING GENERATION V .
2. All Wheel Drive Clutch Pump -V181-
   • Can be checked in "Guided Fault Finding" using the Vehicle Diagnostic Tester
   • Removing and installing. Refer to All Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING, GENERATION V .
3. Data Link Connector
   • Installed location: Front left footwell
4. Accelerator Pedal Position Sensor -G79- and Accelerator Pedal Position Sensor 2 -G185-
   • Removing and installing. Refer to Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing .