Overview - Sunroof, Sunroof Frame: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sunroof

Courtesy of AUDI OF AMERICA, LLC

Frame
- Removing:
- Fold the seat backrest all the way back.
- Lower the headliner. Refer to Roof Trim Panels .
- Sunroof panel removed
- Remove the water drain hoses.
  -- Remove the nuts -4- and screws -2- on the frame.
  
  -- Lift the frame through the rear door and out of the vehicle.
- Installing:
  -- Attach the frame with the nuts and screws loosely to the roof.
  
  -- Connect the water drain hoses.
  
  -- Secure the frame in the body using a 12 mm drill bit on the front right side and a 10 mm drill bit OVERVIEW - SUNROOF, SUNROOF FRAME => Attaching Points for the Frame and then tighten the nuts to the tightening specification beginning at the front center and working back on the left and right sides.
  
  -- Tighten the screws in the same sequence to the tightening specification.
Bolt
- 8 Nm
Wind Deflector
- Removing. Refer to WIND DEFLECTOR, REMOVING AND INSTALLING .
Nut
- 8 Nm
Bolt
- 4 Nm
Motor
- Removing:
  NOTE:
  Remove the motor only when the cover is closed.
  
  -- Interior lamps removed.
  
  -- Disconnect the connector from the motor.
  
  -- Remove the screws -5- and remove the motor through the headliner cut-out.
- Perform and adaptation after removing and installing a motor. Refer to MOTOR ADAPTATION .