Overview - Camshaft Timing Chains
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Jump Protector
- Crankshaft
- With chain sprocket for the camshaft timing chain
- Guide Rail
- Pay attention to the installed position.
- Bolt
- Tightening specification -item 3- OVERVIEW - BALANCE SHAFT => List Item:Bolt .
- Guide Pin
- 5 Nm +90° turn
- Replace
- For guide rail
- Guide Rail
- Pay attention to the installed position.
- Bolt
- 23 Nm
- Camshaft Chain Sprocket
- For the intake camshaft
- Installation position: labeled side is legible from behind
- Guide Pin
- 5 Nm +90° turn
- Replace
- For guide rail
- Chain Sprocket
- For the balance shaft
- Guide Rail
- Pay attention to the installed position.
- Guide Pin
- 23 Nm
- For guide rail
- Camshaft Chain Sprocket
- For the intake camshaft
- Installation position: labeled side is legible from behind
- Bolt
- 23 Nm
- Guide Pin
- 5 Nm +90° turn
- Replace
- For guide rail
- Guide Pin
- 23 Nm
- For tensioning track
- Tensioning Rail
- Chain Tensioner
- For the camshaft timing chain
- Bolt
- 5 Nm +90° turn
- Replace
- Camshaft Timing Chain
- Remove from the camshafts, refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Before removing, mark the direction of rotation with paint
- Removing and installing, refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .