LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Rear Suspension) >> 42 Rear Suspension >> Suspension Strut/Shock Absorber, Spring >> Shock Absorber, Removing And Installing >> Installing

Shock Absorber, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Bonded rubber bushings have a limited range of motion. Only tighten suspension bolts when vehicle is in curb weight or control position.

Wheel bearing, lifting to curb weight position on vehicles with coil springs, refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .

For vehicles with air spring suspension, lift wheel suspension in control position, refer to WHEEL BEARING IN CONTROL POSITION, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Install the wheel housing liner, refer to Wheel Housing Liner .

-- Install rear wheel, refer to WHEELS AND TIRES .

scientia non olet · About LEMON Manuals