Stabilizer Bar, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Bonded rubber bushings have a limited range of motion. Only tighten suspension bolts when vehicle is in curb weight or control position.

For lifting the wheel bearing into curb weight position, vehicles with steel suspension, refer to WHEEL BEARING IN CURB WEIGHT, LIFTING VEHICLES WITH COIL SPRING .

For vehicles with air spring suspension, lift wheel suspension in control position, refer to WHEEL BEARING IN CONTROL POSITION, LIFTING VEHICLES WITH AIR SUSPENSION .

-- Install the stabilizer bar from the left side.

-- Install the left and right bolts -1- so they are still loose and then tighten them evenly.

Fig 1: Left And Right Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install the coupling rod -4- and bolt -2-.

Fig 2: Remove The Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the left and right nuts -3-.

-- Tighten the left and right bolts -1-.

-- Install the rear section from the exhaust system, refer to [For engine(s) CPNB] Exhaust System, Emission Controls .