Rear Brake Rotor, Replacing : Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Raise the vehicle.
-- Remove the wheels.
-- Unclip the wire from the brackets on the stub axle carrier.
-- Remove the brake pads. Refer to Removing .
-- Hang the brake caliper on the body using a suitable wire.
CAUTION:
Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
WARNING:
Do not actuate the brakes or the electromechanical parking brake when the brake caliper is removed.
-- Loosen the brake carrier at the bolts -12-.
-- Install the brake carrier -11-.
-- Hold the brake rotor firmly and remove the locking pin -7- on the brake rotor.
-- Remove the brake rotor.