Brake Caliper, Removing And Installing : Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - REAR BRAKES .

NOTE:

Replace the brake carrier bolts.

Use only mineral spirits or commercially available brake cleaner to clean the brake caliper.

WARNING: Do not blow out the brake caliper with compressed air.

-- Carefully slide the brake caliper with the brake carrier and the brake pads installed over the brake rotor.

-- Tighten the new bolts -arrows- on the brake carrier.

Fig 1: Identifying Screws

Courtesy of AUDI OF AMERICA, LLC

-- Secure the brake hose -2- and wiring harness -3- in the bracket -1-.

Fig 2: Identifying Brake Hose, Wiring Harness And Bracket

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that the electrical wire and brake hose are routed correctly.

Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

-- Install the rear wheel. Refer to Wheels, Tires, Wheel Alignment .

-- Depress brake pedal firmly several times with vehicle stationary so that the brake piston reaches its operating position.

-- Drive the parking brake motor out using the Vehicle Diagnostic Tester by following the directions on the display.

WARNING:

Make sure the brakes are working correctly before driving the vehicle for the first time.

After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check brake fluid level, and fill if necessary.