Overview - Brake Pedal Bracket
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The path of the brake pedal must not be shortened via extra floor mats.
Continued for All Vehicles
- Mounting Bracket for Pedal Assembly
- Removing and installing. Refer to BRACKET, REMOVING AND INSTALLING .
- Remove the steering column. Refer to Steering .
- Pivot Pin for Brake Pedal
- Right Securing Clip (Spring Steel)
- Washer
- Gas Pedal Module Bolt
- 8 Nm
- Accelerator Pedal Module
- Bolt for Attaching The Pedal Bracket to Steering Column
- 20 Nm
- Brake Lamp Switch -F-
-- Refer to Brake Lamp Switch -F-, REMOVING AND INSTALLING
- StopWARNING: If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
- Brake Pedal
Brake pedal and brake booster, disconnecting and connection. Refer to BRAKE PEDAL AND BRAKE BOOSTER, DISCONNECTING AND CONNECTING .
- Removing and Installing. Vehicles with Automatic Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH AUTOMATIC TRANSMISSION .
- Removing and Installing, Vehicles with Manual Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, WITH MANUAL TRANSMISSION .WARNING: If possible, leave the brake pedal stop installed; it could break the mount for the Brake Lamp Switch -F- if the brake pedal is released too quickly.
- Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- Mount for Brake Booster Push Rod
- For the ball head on the brake booster push rod
- With ball stud retaining tabs
- Removing and installing. Refer to MOUNT, REMOVING AND INSTALLING, BRAKE BOOSTER PUSH ROD .
- Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position
- Left Securing Clip (Spring Steel)
- Nut
- 8 Nm