Oil Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
Replace the seals and the O-ring.
Replace any bolts that were tightened with an additional turn.
-- Install the seal -1- for the oil pump.
- The seal is installed on the connection -arrow A- next to the spur gears.
- The second connection -arrow B- does not contain a seal.
-- Install the oil pan lower section, refer to Installing .
-- Install the coolant pump, refer to COOLANT PUMP, REMOVING AND INSTALLING .
-- Install the spur gear unit, refer to SPUR GEAR DRIVE, REMOVING AND INSTALLING .
-- Fill the engine oil and check the oil level, refer to appropriate service information
NOTE:
Do not reuse used coolant.
-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING => Filling .