Overview - Crankcase Ventilation
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification -item 2- OVERVIEW - CHARGE AIR SYSTEM => List Item:Bolt .
- Charge Air Cooler Housing
- With air guides
- Removing and installing, refer to CHARGE AIR COOLER HOUSING, REMOVING AND INSTALLING .
- Grommet
- Bolt
- Tightening specification -item 32- OVERVIEW - CHARGE AIR SYSTEM => List Item:Bolt .
- Seal
- Replacing
- Installed position, refer to Fig 2
- Bolt
- 3.2 Nm
- Hose
- For the crankcase ventilation
- Oil Separator
- Removing and installing, refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Seals
- Replacing
- O-Ring
- Replacing
- Pipe
- For the crankcase ventilation
- Bolt
- 3.2 Nm
- Hose
- For the crankcase ventilation
- Insert the wide nubs -2- into the wide openings -1- and the narrow nubs into the narrow openings.