Overview - Charge Air System
WARNING: This page is about a different car, the 2015 Audi S7, 2015 Audi RS 7, 2014 Audi S7, 2014 Audi RS 7, and 2013 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Charge Air Cooler Housing
- With air guides
- Removing and installing, refer to CHARGE AIR COOLER HOUSING, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Seal
- Replacing
- Seal
- Replacing
- Charge Air Cooler
- Removing and installing, refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- After replacing, replace entire amount of coolant
- Bolt
- 3.2 Nm
- Seal
- For the charge air cooler
- Replacing
- Bolt
- Tightening specification -item 13- THROTTLE VALVE CONTROL MODULE ASSEMBLY OVERVIEW :Bolt .
- Air Guide Hose
- To the air guide pipe at the turbocharger
- Bolt
- 9 Nm
- Turbocharger Recirculation Valve -N249-
- Removing and installing, refer to Turbocharger Recirculating Valve -N249-, REMOVING AND INSTALLING .
- O-Ring
- Replacing
- O-Ring
- Replacing
- Charge Air Pressure Sensor -G31-
- Removing and installing, refer to Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Air Guide
- Seal
- Replacing
- Bolt
- 9 Nm
- Air Guide
- Seal
- Replacing
- Air Guide Hose
- To the air guide pipe at the turbocharger
- O-Ring
- Replacing
- Turbocharger Recirculation Valve Bank 2 -N427-
- Removing and installing, refer to Turbocharger Recirculation Valve Bank 2 -N427-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Charge Air Pressure Sensor 2 -G447-
- Removing and installing, refer to Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- Seal
- Replacing
- Adjusting Buffer
- For the charge air cooler
- Bolt
- 9 Nm
- Grommet
- Seal
- Replacing