Overview - Cylinder Block, Belt Pulley Side
WARNING: This page is about a different car, the 2015 Audi A7 Quattro and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Ribbed Belt
- Check for wear
- Before removing, mark the direction of rotation using chalk or a felt-tip pen.
- Removing and installing, refer to RIBBED BELT, REMOVING AND INSTALLING .
- Do not kink
- When installing, make sure it is seated correctly on the ribbed belt pulleys
- Vibration Damper
- With ribbed belt pulley
- Removing and installing:
- Vehicles without torque support, refer to VIBRATION DAMPER, REMOVING AND INSTALLING, VEHICLES WITHOUT TORQUE SUPPORT .
- Vehicles with torque support, refer to VIBRATION DAMPER, REMOVING AND INSTALLING, VEHICLES WITH TORQUE SUPPORT .
- Washer
- Bolt
- 20 Nm +90° turn
- Replace
- Idler Roller
- For the ribbed belt
- Bolt
- 30 Nm
- Cover
- For the idler roller
- Cover
- For the idler roller
- Bolt
- 23 Nm
- Idler Roller
- For the ribbed belt
- Bolt
- Tightening specification, refer to Specifications .
- Generator
- Removing and installing, refer to Removal and Installation .
- Bracket
- For generator
- Bolt
- Tighten in 2 steps:
- 5 Nm diagonally
- 40 Nm diagonally
- Tighten in 2 steps:
- Bolt
- Tightening specification -item 3- OVERVIEW - COOLANT PUMP => List Item:Bolt .
- Ribbed Belt Pulley
- For the coolant pump
- Coolant Pump
- There are different versions. Use the correct allocation.
- Removing and installing, refer to COOLANT PUMP, REMOVING AND INSTALLING .
- Bolt
- 50 Nm +90° turn
- Replace
- Tensioner
- For the ribbed belt
- Different versions with or without tensioner washer, refer to Fig 2
- Removing and installing, refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .
- Seal
- Replace
- Bracket
- For A/C compressor
- Removing and installing, refer to AUXILIARY COMPONENTS BRACKET, REMOVING AND INSTALLING .
- Bolt
- Tighten in 2 steps:
- 5 Nm diagonally
- 40 Nm diagonally
- Tighten in 2 steps:
- Alignment Sleeve
- Quantity: 2
- Bolt
- Tightening specifications, refer to A/C System, General Information .
- A/C Compressor
- Removing and Installing, refer to A/C Compressor Regulator ValveN280, Removing and Installing .
- Sealing flange MIT tensioner pad
-- Install the tensioner WITHOUT a washer
2 -
Sealing flange WITHOUT a tensioner pad
-- Install the tensioner WITH a washer.
1 -
Bolt - tightening specification -item 18-
2 -
Tensioner
3 -
Washer - not for sealing flange without pad
4 -
Sealing flange - without pad