Rear Bench Seat, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Check Floor Panel For Deformation And Adjust If Necessary

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Lift floor covering -3- and press in new mounting grommets until they engage audibly in body opening -1-.

-- Place floor covering around grommet as illustrated.

NOTE:

The floor panel, into which the mounting grommets are inserted, and the wire frame of the bench seat must be checked after every disassembly of the rear bench seat and be readjusted in the case of deformation. Refer to FLOOR PANEL FOR REAR BENCH SEAT MOUNTING GROMMETS AND WIRE FRAME, CHECKING AND ALIGNING .

Floor covering -3- may not be on grommet -2-.

Make sure the seat heating electrical collections slide on and engage audibly.

-- Install the rear seat bench and push the wire hook -1- forcefully into the grommets -2- -arrow-.

Fig 2: Wire Hook & Grommets

Courtesy of AUDI OF AMERICA, LLC

-- Make sure the wire hooks are engaged correctly in the grommets.