Seat Depth Adjuster, Removing And Installing, MULTICONTOUR Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Lower the front seat all the way down and then raise approximately 1/3.

-- Move seat depth adjuster forward.

-- Remove the front seat. Refer to Removing .

-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture VAS 6136. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove front trim bracket, compressor and multicontour seat control module. Refer to Removing .

-- Remove seat cover and seat cushion. Refer to SEAT PAN COVER AND CUSHION, REMOVING AND INSTALLING, MULTICONTOUR SEAT .

Fig 1: Latches & Depth Adjustment Motor Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Release latches -arrows- with a screwdriver and remove depth adjustment motor carrier -1-

-- Unclip the cover -1- from the lower seat frame -A arrows-, disengage is from the seat depth adjuster -arrows B- and remove it.

Fig 2: Cover & Seat Depth Adjuster

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect and free up the connector -3-.

Fig 3: Connector, Seat Depth Adjuster Motor & Seat Angle Adjustment Motor

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -1- and -4- and the seat depth adjuster motor -2-.

-- Remove the screws -1- and move the seat angle adjustment motor -4- to the side.

Fig 4: Disconnect Electrical Harness Connector On Seat Angle Adjustment Motor

Courtesy of AUDI OF AMERICA, LLC