Front Three-Point Seat Belt, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install in reverse order of removal. Note the following:

-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.

NOTE:

Make sure the connectors are installed correctly and are secure.

-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount -2- -arrow- and tighten the bolt.

Fig 1: Identifying Hooks On Belt Roller/Belt Tensioner And Side Panel (Chassis-Body Structure)

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- After installing the three-point seat belt on the front passenger side, check the child seat anchorage function (depending on the country) of the belt. Refer to SEAT BELT FOR CHILD SEAT, CHECKING CHILD SEAT RESTRAINT FUNCTION, MARKET-SPECIFIC .

-- After replacing the front three-point seat belt with the Driver Seat Belt Tensioner Igniter 1 -N153- / Driver Belt Force Limiter -G551- / Left Front Seat Belt Tensioner Control Module -J854- / Front Passenger Seat Belt Tensioner Igniter 1 -N154- / Front Passenger Belt Force Limiter -G552- / -J855-, it must be coded using the Vehicle Diagnostic Tester.