Seat Belt For Child Seat, Checking Child Seat Restraint Function, Market-Specific

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

To check function, you must install entire belt system, including side trim.

Switching Hold Function On

Pull out seat belt as far as the stop.

Correct Function

Belt must retract with a chattering sound.
If retracting process is stopped, belt cannot be pulled out anymore.

Deactivating

Belt retraction to about 100 mm remaining.
Hold function must switch off with a remainder of 100 mm, at the latest. Belt functions normally again.

If the seat belt child seat anchorage does not work, replace the seat belt