Passenger Occupant Detection System, Removing And Installing: Installing
- Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
- Observe all measures when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
Installation is performed in reverse order of removal, while noting the following:
Make sure the connectors are installed correctly and are secure.
Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
When installing a new service kit and after each repair on the front passenger seat where the seat and/or the backrest cover is >>disengaged<<, a basic setting procedure must be performed on the seat occupied recognition control module. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
-- Select "airbag" in "Guided Fault Finding" to complete. Refer to Vehicle Diagnostic Tester.
- -J706 Passive occupant detection system control module basic setting
If the Airbag Indicator Lamp -K75- signals a fault after installing, check the DTC memory, erase it and check it again. Refer to Vehicle Diagnostic Tester.
Installation note: For example, tightening specifications and replacing components. Refer to COMPONENT LOCATION OVERVIEW - PASSENGER OCCUPANT DETECTION SYSTEM and OVERVIEW - PASSENGER OCCUPANT DETECTION SYSTEM .