LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Passenger Protection, Airbags & Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Passenger Occupant Detection System >> Component Location Overview - Passenger Occupant Detection System >> Component Location Overview - Passenger Occupant Detection System

Component Location Overview - Passenger Occupant Detection System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

The replacement part (Service Kit) for the passenger occupant detection system (country-specific) is already pre-installed. Never disconnect the connector between the Passenger Occupant Detection System Control Module -J706- and the Passenger Occupant Detection System Pressure Sensor -G452-. The Service Kit differs depending on the seat version and consists of:

Standard Seat/Sport Seat/Super Sport Seat: 

  • Seat cushion with/without a seat heating element
  • Passenger Occupant Detection System Pressure Sensor -G452- attached to the seat cushion or seat heating element
  • Passenger Occupant Detection System Control Module -J706-

Multi-Contour Seat: 

  • Passenger Occupant Detection System Pressure Sensor -G452- sewn in with seat heating element in the seat cover
  • Passenger Occupant Detection System Control Module -J706-
WARNING:

Follow all safety precautions when working on the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .

NOTE:

The passenger occupant detection system is only installed in the front passenger seat.

Fig 1: Component Location Overview Of Passenger Occupant Detection System
GWWA69-10755Courtesy of AUDI OF AMERICA, LLC
  1. Connector
    • Between Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
      CAUTION:

      Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Seat Occupied Recognition Control Module -J706-.

  2. Connector
    • Between the connector station under the seat and the Passenger Occupant Detection System Control Module -J706-.
  3. Passenger Occupant Detection System Control Module -J706-
  4. Front Passenger Seat Belt Switch -E25-
  5. Front Passenger Airbag -Disabled- Indicator Lamp -K145-
  6. Airbag Control Module -J234-
  7. Connector Station
  8. Passenger Occupant Detection System Pressure Sensor -G452-
    • Different versions:
      • Standard seat/sport seat/super sport seat: Passenger occupant detection sensor bonded with seat cushion or seat heating element
      • Multi-contour seat: The multicontour seat and seat heating element are sewn inside the seat cover
      CAUTION:
      • Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Seat Occupied Recognition Control Module -J706-.
      • Never disconnect the passenger occupant detection sensor from the seat cushion or the seat cover.
    • Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
scientia non olet · About LEMON Manuals