Relay And Fuse Panel In Plenum Chamber E-Box: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Control Module -J623- Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and disconnect the ground cable from the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the washer fluid reservoir filler neck. Refer to WASHER FLUID RESERVOIR FILLER NECK .

-- Release the retainer -arrow-, remove the engine control module -1- and move it to the side with the wires still connected.

NOTE: Disregard item -2-.

-- Remove the screws -arrows- and remove the cover -1- for the right plenum chamber E-box.

Fig 2: Identifying Bolts And Cover

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connectors -1- and remove the nut -2- for the electric wire.

Fig 3: Identifying Connectors And Nut

Courtesy of AUDI OF AMERICA, LLC

-- Open the retainers -arrow- and remove the relay panel and fuse panel -4-.

-- Remove the nut -3- for the electric wire.

-- Release the tab -arrow-, push fuse panel A -2- to the rear and disengage it from the relay panel -1-.

Fig 4: Identifying Push Fuse Panel A

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip and remove the auxiliary fuse panel -2-.

Fig 5: Identifying Auxiliary Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Open the clips -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Release the retaining clips -arrows- and press the relay carrier -3- back and out of the bracket -4-.

Fig 6: Identifying Relay Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- and remove the connector -1-.