LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> A7 Quattro Competition >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Wiring) >> 97 Wiring >> Removal And Installation >> Relay And Fuse Carriers, Passenger Compartment >> Relay Panel Mount, Under Instrument Panel, Left Side, Vehicle Electrical System Control Module >> Removal

Relay Panel Mount, Under Instrument Panel, Left Side, Vehicle Electrical System Control Module: Removal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Nuts And Mount
GWWA97-11255Courtesy of AUDI OF AMERICA, LLC

-- Remove the vehicle electrical system control module. Refer to REMOVAL .

-- Remove the headlamp range control module. Refer to CORNERING LAMP AND HEADLAMP RANGE CONTROL MODULE .

-- Remove the left instrument panel vent. Refer to FRONT PASSENGER SIDE INSTRUMENT PANEL VENT AIR GUIDE, REMOVING AND INSTALLING .

-- Slide the extension -2- from the socket set between the air duct -3- and the instrument panel.

-- Remove the nuts -4 and 5-.

-- Remove the mount -6- from the threaded pins.

-- Disengage the retaining pins -1- on the mount at the side guide in the A-pillar -arrow- while pulling the mount toward the passenger compartment.

-- Release the tabs -3- -arrow A- and disengage the mount for the headlamp range control module -1- from the mount -2- -arrow B-.

Fig 2: Identifying Headlamp Range Control Module
GWWA97-11256Courtesy of AUDI OF AMERICA, LLC