Center Differential Ball Bearing, Removing And Installing: Procedure

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Remove Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing. Refer to Removing .

-- Remove the center differential -1- from the input shaft.

-- Removing the ball bearing from the center differential

Fig 2: Ball Bearing Removed From Center Differential

Courtesy of AUDI OF AMERICA, LLC

A -

Separating tool 22 to 115 mm Kukko 17/2

The Press Piece - Bushing - 50 mm Diameter VW 432 faces the ball bearing.

-- Installing the ball bearing onto the center differential

Fig 3: Ball Bearing Installed Onto Center Differential

Courtesy of AUDI OF AMERICA, LLC